Sloping Cross (0-11 degrees) for 48mm Galvanised Pipe Treated Baluster Where would you normally use

Where would you normally use a treated timber wall plate

This fitting may sometimes be used to fix flat sheets to tubes

made from H3 treated radiata pine

The 140 Gate Hinge Pin is often used with type 138 to form gate hinges

It is now supplied un-primed

Sloping Cross (0-11 degrees) for 48mm Galvanised Pipe Treated Baluster Where would you normally useWhere would you normally use this galvanised pipe fitting? The 156 Slope Cross (Middle Rail) is adjustable for slopes from 0 degree to 11 degree, and normally used between middle rail and uprights on sloping sites and often paired with type 153 or 155. The through tube (vertical in photo) cannot be joined within the fitting. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 48mm.