90 degree Elbow for 48mm Galvanised Pipe Fretwork It is suitable for both

It is suitable for both interior and exterior use

On top of a 90 x 90mm fence or stair post to dress it up

this fitting can reduce the need for cutting on horizontal rails

(The baluster is the part between the top handrail and bottom rail)

The 119 90 degree joint

90 degree Elbow for 48mm Galvanised Pipe Fretwork It is suitable for bothWhere would you normally use this galvanised pipe fitting? The 125 is a 90 degree angle joint, often used where top rail meets end upright on level sites. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 48mm. What is it made out of? All of the pipe fittings are made from malleable iron and then hot dipped galvanised to exceed the requirements of AS NZS 4680: 2006, giving a