90 degree Elbow for 27mm Galvanised Pipe clearance This fitting will work with

This fitting will work with horizontal galvanised pipe (tube) of an outside diameter of approximately 48mm

but this is now no longer the case

We recommend using nails or an exterior grade glue to fix the 4 pieces together on the post

The 116 is a 90 degree corner joint

Where would you normally use a Tulip fretwork panel

90 degree Elbow for 27mm Galvanised Pipe clearance This fitting will work withWhere would you normally use this galvanised pipe fitting? The 125 is a 90 degree angle joint, often used where top rail meets end upright on level sites. What size pipe does it fit to? This fitting will work with galvanised pipe (tube) of an outside diameter of approximately 27mm. What is it made out of? All of the pipe fittings are made from malleable iron and then hot dipped galvanised to exceed the requirements of AS NZS 4680: 2006, giving a