LDO Toolhead PCB for Stealthburner/Afterburner Wrench hotend) on the toolhead PCB

hotend) on the toolhead PCB into a single cable

“Rx1” pads are for ESC Telemetry

The acclaimed ToolkitRC M9 is a multi-function balance charger with all-in-one features

Browse all Extruders

No voltage drop and heat on current sensor components

LDO Toolhead PCB for Stealthburner/Afterburner Wrench hotend) on the toolhead PCBAre you looking to buy an LDO Toolhead PCB in Australia? For use in conjuction with the breakout board and Toolhead Cable by LDO The Toolhead PCB The toolhead PCB is based on hartk's toolhead PCB design. The main purpose of the toolhead PCB is to combine all the signals and wires (e. g. thermistors, fans, hotend) on the toolhead PCB into a single cable. Compared to the orignal hartk design, the LDO PCB has a few minor differences: The hotend cartridge